This page summarizes published safety guidance. It is not a substitute for instruction, and conditions on your water may differ. Check the current rules for the state and water you paddle.
Key Takeaways
These are Well Paddled’s rules for choosing the right information:
- If you paddle a river, choose your section on the USGS map and select discharge and gage height.1
- If a dam affects your route on TVA waters, select the dam in Lake Levels.3 The Buffalo National River example below is undammed.
- If water height affects your coastal launch or landing, choose NOAA tide predictions, supplemented by observed levels where available.2,5
- If current direction or timing affects your route, choose NOAA Current Predictions; high and low tide do not identify slack water.2,6
- If readings are old, provisional, changing or separated from your route by dams or tributaries, check local warnings and hazards; agency staff may not know about new obstructions. Choose another route or postpone if conditions remain unclear or exceed your skills.7,8,4
Read a river gauge
Your reach is the river section between your put-in (where you enter the water) and take-out (where you leave it). A nearby gauge may measure a different reach.4,7,8 Read the station identity, latest observation, measured quantities and recent graph in that order.
- Confirm the name and location. Make sure you have selected the intended river station.1
- Read the timestamp and quality flag. Recording and transmission happen separately, so the newest displayed observation may lag behind conditions. A “P” flag means provisional: subject to revision before final approval. Instrument problems, physical changes at the site and later field measurements can lead to significant revisions.7,1
- Separate flow from height. Discharge, or streamflow, is the volume passing a location per unit of time. Cubic feet per second (cfs) measures that volume. It is not your boat’s speed: discharge depends on both the area carrying water and its velocity.9
- Inspect the recent graph. Rising values show an increase during the displayed period; falling values show a decrease. Neither projects conditions after the last reading.1
Gage height and discharge
Gage height, also called stage, is water height above an established zero. That reference elevation is the datum. Stage generally does not show channel depth, the river bottom or where flow stops. The relationship between stage and discharge differs at every gauge.
Water held back downstream—backwater—can raise stage without a corresponding increase in flow. USGS may replace discharge with a condition code when backwater affects a gauge. If discharge is unavailable, stage alone cannot check a cfs limit; choose another route or postpone if the needed flow remains unclear.9,7
Do not turn stage into depth along your route: depths vary by location. Even a published mean velocity is only an approximate indication of water speed at the location where measurements were made.7
A dated USGS example
At Buffalo River at Ponca, Arkansas, USGS recorded provisional discharge of 2.69 cfs and stage of 1.68 feet at noon Central Daylight Time on October 12, 2026.10 At noon on October 13, 2026, the corresponding readings were 2.65 cfs and 1.66 feet.10 Both quantities fell slightly between those observations; these are historical readings, not current conditions.10
For a historical comparison, match the statistic and calendar day. USGS’s provisional October 12 daily mean—an average covering that day—was 2.68 cfs, subject to revision.11 Its historical record gives an October 12 median of 6.4 cfs, using 17 daily means from water years 2009–2025.
The median is the middle value when those observations are sorted. That day’s mean was below the historical median; this comparison does not establish depth, navigability or safety.11,12,13,4
Read coastal height and current separately
Find a tide station by map, name or station identifier. Predictions depend on measurements collected and analyzed at that location. Reference-station predictions use locally derived values; subordinate stations derive their predictions from a reference station by adjusting its times and heights.14 Before interpreting the result, check the station, trip date, time zone, units and datum.
Check the station, trip date, time zone, units and datum
For secondary-port tide calculations using its tables, the Canadian Hydrographic Service says to note the port’s time zone.15 NOAA’s LST means local standard time without daylight-saving adjustment. Choose LST/LDT for local clock times adjusted for daylight saving when applicable.14
Subordinate stations provide high/low predictions only, relative to Mean Lower Low Water (MLLW), the coastal chart reference level. A height relative to MLLW is not a direct measurement of depth everywhere on your route.14
Tide predictions and actual levels
Tide predictions describe astronomical tides. Wind, rain, freshwater runoff and other short-term weather effects can change actual levels or mask that pattern completely. NOAA also gives a station example where weather can advance or delay predicted tides by an hour or more.
NOAA notes that outer-coast predictions are more accurate than predictions farther inland. Where observations exist, compare measured and predicted heights using matching units and reference levels.2,5
Slack water and current predictions
Slack water means little or no horizontal water movement. Its relationship to high and low tide is specific to each location, so use current predictions for slack times and maximum current speeds.2
The Open University says that in many estuaries and other areas with high tidal ranges the 50/90 rule is observed: from slack water, the tidal stream’s speed is approximately 50%, 90%, 100%, 90%, 50% and 0% of its maximum at hours 1 through 6.16
Read a current result
On a current result, read the representative depth where shown, speed units, date, time zone and mean directions. Flood generally flows inward; ebb flows outward. Negative speeds indicate the displayed mean ebb direction. Check the displayed speed unit before interpreting the number.2,6
The Mountaineers’ Kayak Trip Planning Tool includes fields for recording the current station and the times of maximum ebb, slack water and maximum flood.17
The British Canoeing Awarding Body’s Navigation for Paddlers sample session plans give approximately 2-3 km per hour (about 1.2-1.9 mph) as a very rough planning speed for new paddlers in general-purpose SUPs, kayaks and canoes, and note that wind and tide will affect speed in coastal areas.18
Station details and prediction table
Some station details may be approximate, and predictions are unavailable for certain weak-current stations. After changing options, click Submit to update the output. A user-selected speed highlight is a display setting, not a safety limit.6
NOAA’s Current Predictions guide says you can download the prediction table in TEXT, CSV or XML format using the buttons above the table.19
Treat dam schedules as changeable plans
TVA’s generation schedule shows how many generators are expected to operate and when, rather than guaranteeing downstream flow. Its recreational release calendar is another planning source.20
Check updates before leaving: schedules are updated during the day and can change without notice because of weather or power requirements. Large discharges can occur at any time.3 Idaho Power says water travel time below Hells Canyon Dam can be influenced by flows from other sources and can vary depending on the shape of the releases.21
Avoid dams while water is released
For TVA waters, avoid dams while water is released through spillways, turbines or navigation locks. Sudden releases deepen the river and strengthen currents; dangers can extend far downstream, and currents can be difficult to escape even in a motorboat. The National Weather Service warns that even 6 inches of fast-moving water can knock over and carry away an adult.8,22
Stay out of restricted areas and obey posted precautions. If release-warning sirens or lights activate, leave the areas upstream and downstream of the dam immediately.8
Finish the launch decision locally
A gauge cannot report every obstruction. Buffalo National River warns that a newly fallen tree can block a channel below a gauge, and not all trees are removed. Avoid strainers—trees or branches that pass water but trap paddlers—and sweepers, fallen trees across the river or along its edge. These hazards may be above water, partly submerged or just below the surface, often on the outer side of bends or in fast, narrow chutes.4,8
Local limits and low water
Local limits belong to their named river. In guidance updated October 2, 2026, Buffalo National River identifies flows greater than these values as unsafe: Ponca, 1,600 cfs; Pruitt/Highway 7, 2,000 cfs; Grinder’s Ferry/Highway 65, 8,000 cfs; and Dillard’s Ferry/Highway 14, 9,370 cfs.4
A lower reading still requires hazard and skill checks. If low water would mean prolonged hauling to the next take-out, alter your trip.4
Check weather and match conditions to your abilities
Check weather as well as water data. Buffalo warns that thunderstorms can cause rapid changes far from the storm itself; TVA advises against paddling rivers or streams after heavy rain when they are flooding. Match conditions to your abilities, wear your life jacket and share your route and return time with someone who can call for help.4,8
For more detail, use paddling weather and wind, float plans and trip communication and river access law by state. The safety hub covers related preparation.
Footnotes
-
https://waterdata.usgs.gov/monitoring-location/USGS-07055660/ ↩ ↩2 ↩3 ↩4 ↩5
-
https://www.nps.gov/buff/planyourvisit/paddling.htm ↩ ↩2 ↩3 ↩4 ↩5 ↩6 ↩7 ↩8
-
https://tidesandcurrents.noaa.gov/noaacurrents/help.html ↩ ↩2 ↩3
-
https://mn.water.usgs.gov/infodata/FAQStreamgaging.htm ↩ ↩2 ↩3 ↩4 ↩5
-
https://www.tva.com/environment/lake-levels/hazardous-waters ↩ ↩2 ↩3 ↩4 ↩5 ↩6
-
https://www.usgs.gov/water-science-school/science/how-streamflow-measured ↩ ↩2
-
https://waterservices.usgs.gov/nwis/iv/?format=json&sites=07055660&startDT=2026-10-12&endDT=2026-10-13¶meterCd=00060,00065 ↩ ↩2 ↩3
-
https://waterservices.usgs.gov/nwis/dv/?format=json&sites=07055660&startDT=2026-10-12&endDT=2026-10-13¶meterCd=00060 ↩ ↩2
-
https://waterservices.usgs.gov/nwis/stat/?format=rdb&sites=07055660&statReportType=daily&statTypeCd=median¶meterCd=00060 ↩
-
https://tidesandcurrents.noaa.gov/noaatidepredictionshelp.html ↩ ↩2 ↩3
-
https://waves-vagues.dfo-mpo.gc.ca/Library/chs-shc-tct-tmc-vol6-2022-41025726.pdf ↩
-
https://web.archive.org/web/20260112232217/https://www.open.edu/openlearn/science-maths-technology/engineering-environmental-fluids/content-section-4.4 ↩
-
https://www.mountaineers.org/locations-lodges/seattle-branch/committees/seattle-sea-kayaking-committee/test/tides-and-currents/kayak-trip-planning-tool/%40%40download/file/Kayak%20trip%20planning%20tool.pdf ↩
-
https://britishcanoeingawarding.org.uk/wp-content/files/BCABNavigationForPaddlersModuleSampleProgrammeAndSessionPlansV1-1Feb25.pdf ↩
-
https://tidesandcurrents.noaa.gov/education/tech-assist/training/user-guides/assets/pdfs/Current_Predictions_User_Guide_v5.pdf ↩
-
https://www.tva.com/the-powerhouse/stories/leveling-up_rec_tech ↩