Care and transport

How to Store an Inflatable Kayak

Storage choiceWhen it fitsMaker and condition
Deflated and packedYour model’s instructions call for deflation; follow its own fold and valve sequence.Advanced Elements extended storage; Intex Challenger K2. Keep dry and follow the location conditions below.1,3,2
Unfolded with some airYou have room to leave the boat unfolded and can keep it cool and dry.NRS Pennel Orca manual prefers a small amount of air in the chambers.4
InflatedYour maker permits it and you can meet its support and storage conditions.Sea Eagle RazorLite may be stored inflated; support it along its full length if hung.5

Clean and dry every layer

Advanced Elements says to rinse its kayak with fresh water and air-dry it before extended storage. Its FAQ allows soft liquid soap or diluted Simple Green; the AdvancedFrame Elite manual warns against strong solvents.

For that model, deflate it before opening the chamber covers. Open both center zippers, unscrew the spring-valve locking nut before fully separating the gray tube cover and inflatable floor from the outer cover, then wipe the outer cover and both sides of the floor dry. Do not pack it wet for extended storage.1,3

Intex Challenger K2 and Sea Eagle RazorLite

For the Intex Challenger K2 covered by its manual, use a garden hose, sponge and mild soap, then make sure the kayak is completely dry. For a Sea Eagle RazorLite, close the air valve and cap while rinsing, then check the chambers for water before rolling; water can drain through open valves when rolled. 2,5,6

Moisture or mildew inside a Pennel Orca chamber

If a Pennel Orca chamber has moisture or mildew inside, NRS directs owners to remove the affected valve and put an electric pump’s hose through the valve opening to move air through the chamber until the moisture is gone. This is an NRS procedure for that boat family, not a general instruction to remove valves from other inflatables.4

Deflate and fold by model

Advanced Elements’ AdvancedFrame Elite sequence is to remove the caps from chambers 1–3, push and rotate their stems to deflate, then open the twist valves (valves opened by turning) on chambers 4–7.

After drying, remove the plastic forms at the bow (front) and stern (back) and the seat, lay the kayak flat, fold it in half down the center from right to left, then fold it into four equal sections and place it in the kayak’s duffel bag (storage bag). The manual says to pump out remaining air after deflation.3

Intex Challenger K2

For the Intex Challenger K2, open all valves, deflate completely and remove accessories. Turn the kayak over; fold the left side in, then the right side over it.

Fold the bow twice toward the middle while expelling air, repeat at the stern, replace the valve caps, and bring the ends together like closing a book. Pack loosely and avoid sharp bends, corners and creases.2

Sea Eagle RazorLite

For a Sea Eagle RazorLite, remove the seat, FlexBrace pedals (the removable foot pedals) and skeg (the tracking fin under the kayak), then fold it by model. With the valves open, fold the sides over the floor.

393rl and 473rl

For the 393rl, fold the rear at the 393RazorLite logo with the nose off-center, install the skeg-base insert, fold the front at the SeaEagle.com logo with the bow opposite the rear, bring the ends together with the noses offset, then strap and bag it wide end first.

For the 473rl, fold the front at the SeaEagle.com logo toward the rear and twist it flat, fold rearward again, crease at the floor valve and fold and twist flat, fold forward once more, align the top and bottom folds, press out air, then strap and bag it wide end first.

To deflate either, push down on the valve stem and turn it a quarter turn to the right. Keep your face away from the valve because air escapes with force.5

Deflate with the Mega Pump

To deflate with its Mega Pump, Sea Eagle says to move the hose from the inflation inlet to the deflation outlet, twist clockwise to tighten it and insert the adapter into the valve.7

NRS Pennel Orca

NRS says to store its Pennel Orca boat loosely rolled with valves open if you cannot leave it unfolded; use a protective bag or cover.

When deflating a fully inflated boat, NRS says not to fully open only one chamber, because that strains the internal baffles and can rupture them; release the pressure in all chambers at the same time, or release small amounts from each chamber until the valves can be opened safely. Its manual advises against using a vacuum or deflator to suck all the air out unless absolutely necessary.4

Choose the location

Intex’s Challenger K2 manual says not to store the kayak inflated and specifies temperature-controlled, dry storage between 32 and 104 degrees Fahrenheit (0 and 40 degrees Celsius).2 The AdvancedFrame Elite manual says to avoid temperature extremes; if this model was stored below freezing, let it warm before unfolding.

Sea Eagle says not to store a RazorLite in direct sunlight, an attic or a metal shed. In freezing temperatures, wait until it reaches room temperature before dropping, striking or unrolling it.2,3,5

Sunlight, rain and rodents

If a RazorLite must be outdoors, Sea Eagle says to raise it off the ground and cover it from sunlight, rain, leaves, berries and bird droppings. NRS says to keep its Pennel Orca boat off dirt or concrete because rodents may burrow into stored rafts.

Storage in a shed

For a Sea Eagle stored in a shed, its FAQ recommends a large plastic bin or clean garbage can with a tight lid, and says the boat must be clean and completely dry first. That container does not make a metal shed suitable for a RazorLite; Sea Eagle says not to store that model in a metal shed.

Red’s board guide excludes hot or humid storage.5,4,8,6

The disagreement is about product and storage duration. Inflatable Kayak World says it does not matter whether an Advanced Elements kayak is inflated or deflated when you use it continually, then advises deflating, drying and bagging it for longer storage. For weeks or months between trips, follow the maker’s extended-storage guidance.

After storage

After storage, inspect the kayak for loose items, damage and leaks before using it again.5,9,1,2,4,10 For more on storing other kayak types, see how to store a kayak and the care and transport guide.

Footnotes

  1. https://www.confluenceoutdoor.com/pages/advanced-elements-faq ↩ ↩2 ↩3 ↩4

  2. https://intexsupport.com/file/user-manual-for-68306np-en-2024/f-22987/ ↩ ↩2 ↩3 ↩4 ↩5 ↩6 ↩7

  3. https://media.pelicaninternational.com/m/3b3ec619b0920a8e/original/AE1012-E_OM.pdf ↩ ↩2 ↩3 ↩4

  4. https://www.nrs.com/assets/downloads/inflatables/48209_v5_owner%27s%20manual_hypalon.pdf ↩ ↩2 ↩3 ↩4 ↩5

  5. https://www.seaeagle.com/img/InstructionalPDF/2025%20RazorLites.pdf ↩ ↩2 ↩3 ↩4 ↩5 ↩6

  6. https://cdn.shopify.com/s/files/1/0525/6462/3524/files/Online_User_Guide_-_English.pdf?v=1678900497 ↩ ↩2

  7. https://www.seaeagle.com/img/PDF/AccessoryInstructions/25.pdf ↩

  8. https://www.seaeagle.com/Faq ↩

  9. https://www.inflatablekayakworld.com/advanced-elements-faq/ ↩

  10. https://red.equipment/pages/faqs ↩