Care and transport

Carrying Two or More Kayaks on One Car

The roof rack supports the crossbars above your car; the kayak carrier holds the boats on those bars.

This page summarizes published safety guidance. It is not a substitute for instruction, and conditions on your water may differ. Check the current rules for the state and water you paddle.

Key Takeaways

  • Check your vehicle’s roof allowance in its owner’s manual.1
  • Check the carrier’s boat allowance separately from the total roof-load allowance.1,3
  • Confirm mounting fit and space for every boat before buying another carrier.4,5
  • Check that you have the required straps and end tie-downs for every kayak.2,6

Check all the load limits together

Start with your vehicle’s owner’s manual, then check the rack maker’s vehicle fit guide and your carrier’s instructions. A fit guide is the maker’s lookup for your particular vehicle and roof arrangement.

Yakima’s BigStack instructions direct you to its online rack limit—the rack maker’s weight ceiling, separate from the car’s roof allowance; Malone directs owners of factory racks—the crossbars the car maker fitted at the factory—to its Fit Guide for the required mounting bolts.1,2,4

Count the total roof load

For the total roof load, Thule includes the rack, fitted carriers and accessories, and the cargo itself. Use the dynamic limit while driving, not a higher static allowance for a parked vehicle, as explained in roof load limits explained. Count every kayak and anything else carried on the roof.

In its cargo-box guidance, REI advises subtracting the weight of the box and any other rack accessories you use, such as kayak racks, from your vehicle’s maximum load.7

Check the vehicle and rack limits

Yakima’s Australia and New Zealand load-rating document lists a maximum on-road dynamic rating of 165 pounds (75 kilograms) for its P-Bar Standard Bar.8 SEAT’s Ateca manual says to check the weight of your roof carrier system, crossbars, and cargo and weigh them if necessary.9

Thule says the lower recommended maximum applies when the vehicle and rack assembly have different limits.1 The AA says you should ideally weigh everything you plan to carry on the roof and reminds you to include the roof rack’s own weight.10 Keep the carrier’s boat allowance separate.

Keep the carrier’s boat allowance separate

For example, Thule Compass’s two-kayak allowance covers the boats together. It does not replace the vehicle’s total-load limit, which includes mounting parts such as clamps and bolts. You must stay within every applicable allowance; whichever limit restricts your proposed arrangement controls what you can carry.3,1

For more on finding and reading those limits, see roof load limits explained.

In Yakima Support’s worked example, a 165-pound limit minus 40.2 pounds of rack and accessories leaves 124.8 pounds for cargo.11

Choose an arrangement made for your boats

A stacker holds kayaks on their sides beside upright supports. Thule notes that the vehicle’s total height increases when upright loads are carried.1 Our advice: measure the loaded height and check clearance before entering garages, carports or other low entrances.

A J-cradle is an angled support for one kayak. Thule describes its Hull-a-Port as a space-saving J-style cradle.12 Saddles support a kayak with its hull—the body of the boat—facing down. Makers sell different arrangements, so check both the configuration and its allowance.13,14,15,4

Yakima lists the BigStack carrier itself at 7.2 pounds.13 REI describes foam blocks as inexpensive temporary carriers that are easy to install and often do not require a base roof rack.16

Carrier or arrangementWhat the maker sells it forHow to read the allowance
Yakima BigStackA folding stacker for up to four boats, especially multiple whitewater boatsYakima’s catalog entry lists 150 pounds combined for four kayaks. Vehicle and rack limits also apply.13,2
Yakima JayLowOne kayak in J-cradle position, or two in upright stacker positionThe current one-boat allowance is 100 pounds (45 kilograms). Confirm the two-boat allowance for your unit as explained below.14,6
Thule CompassOne kayak in J-style or saddle position, or two in stacker positionThe two-kayak allowance is 130 pounds (59 kilograms) combined. Kayaks may be up to 36 inches wide.15,3
Malone Stax Pro2 MPG115MDUp to four kayaksMalone lists 50 pounds per boat and a four-boat maximum. Keep those as separate limits.4
Separate Malone DownLoader MPG114MD setsOne kayak in each side-loading J-style setTwo boats require two complete sets, with sufficient space and approved fit.4,5
Separate Malone SeaWing MPG107MD setsOne kayak in each hull-down, rear-loading setMalone lists 75 pounds for one SeaWing set. Side-by-side boats require separate sets.4,5

One carrier set commonly has a support on each crossbar. JayLow’s instructions list its units as a pair (2X).14 Our advice: count the front and rear supports of one set as one carrier for one kayak, and two single-kayak J-cradle sets as two complete sets, not as two individual supports.

Yakima says its BigStack carrier is lockable with SKS Lock Cores, sold separately.13

Confirm JayLow’s rating for your unit

Yakima’s current JayLow product page lists 130 pounds combined for two boats.14 However, the linked instruction sheet, version H, shows 110 pounds (50 kilograms) in the two-boat section and 130 pounds elsewhere.6 Our advice: have Yakima confirm the applicable rating and instructions for your unit before using the higher allowance.

Yakima separately identifies units manufactured before February 1, 2026: those are rated for one boat up to 80 pounds or two boats up to 110 pounds combined.14 Check the manufacture date, not just the purchase date.14 A lift-assist carrier also needs its own checks.

A lift-assist carrier

Thule says its Hullavator Pro is for one kayak, with a 75-pound kayak capacity and gas-assist struts that lift and lower 40 pounds of the kayak’s weight.17 That lifting help does not increase the roof allowance.17,1

Thule lists the Hullavator Pro’s included tie-downs as for transporting one kayak.17 Our advice: before you install two units on one car, ask your Thule dealer about the limits of the product and of your roof.

Check crossbar spread, width, and mounting

Crossbar spread is the front-to-rear distance between the two bars, not their length across the car. Each carrier has its own requirement:

  • Yakima BigStack requires at least 24 inches of spread.2
  • Current Yakima JayLow instructions require 27.5 inches (69.85 centimeters); units manufactured before February 1, 2026 require 24 inches (61 centimeters).14,6
  • Thule Compass requires at least 24 inches (610 millimeters).3

Meet the requirement for your exact carrier and version. If you have BigStack on a factory rack, follow Yakima’s vehicle-specific fit-list notes.2

Check the available width

Next, check the available width across the bars. Adding a separate carrier set depends on the space taken by both boats and the crossbars.

Malone does not publish a numerical gap between boats or minimum usable bar width for two DownLoader or SeaWing sets in the checked pages and guides; the checked Yakima and Thule guides also give no general two-boat spacing figure. If clearance is unclear, ask the maker to confirm fit for your vehicle, bars, carriers and boats.

A boat’s width limit is a separate check from whether the carrier mounts correctly on the bars.5,15

Before choosing longer bars, confirm the approved bar length and mounting arrangement through the rack maker’s fit guide. Thule also requires even load distribution and limits how far cargo extends beyond the carrier.4,1 Compare carrier types in kayak roof racks compared, then check the maker’s instructions for your vehicle and chosen configuration.

Secure every boat in the prescribed arrangement

Check the complete carrier diagram before loading several kayaks. Boat count and included equipment are separate checks: BigStack warns that more than two kayaks may need extra straps, while JayLow’s two-boat instructions require another Heavy Duty Strap (a securing strap of the type included in the kit) and Bow Stern Tie-Down (a set of lines securing the kayak’s front and back to the vehicle).2,6

The bow is the front of the kayak; the stern is the back. Yakima requires bow and stern attachments for BigStack and JayLow. Each boat needs its prescribed end attachments; one pair of lines does not secure the whole group.2,6

Yakima warns that failing to secure the front and rear of long loads to the ends of the vehicle can result in property damage, personal injury, or death.13

BigStack, JayLow and Thule Compass

If you have BigStack, follow its illustrated strap path beneath the crossbar and inside the tower—the support attaching the bar to the car—and its separate Strap Cap option—an optional accessory for routing the strap—when that routing cannot be maintained.2

If you have JayLow, its instructions require Hood Anchors—alternative vehicle attachment parts for the bow and stern lines—where suitable attachment points are absent or lines would damage the vehicle; contact Yakima if those options do not work.6

Thule Compass includes two sets of load straps and bow/stern tie-downs for its two-boat arrangement. Check another carrier’s contents before assuming its kit equips both boats.15,18

Check straps before driving

Make straps snug without excessive tension. REI warns that overtightening can deform plastic hulls or crack fiberglass.5

Before driving away, BigStack instructs you to test movement by rocking the boat and to tighten again if loose, then to check straps periodically during travel and tighten if necessary.2 REI recommends a simple twist in the cam straps to help prevent vibration while driving.5

Speed with a roof load

A roof load increases sensitivity to side winds. Adjust your speed to the load, road, wind and traffic conditions, and obey applicable speed limits. Thule says never to exceed 80 mph (130 km/h) with a roof load; conditions may require a lower speed.1 Thule also says to drive slowly over speed bumps, at no more than 6 mph (10 km/h).1

For the full securing process, see how to tie down a kayak.

Check whether the boats may touch

Use your carrier’s exact loading diagram and your kayak maker’s transport instructions to decide whether adjacent hulls may touch. Ask the maker if contact or padding requirements are unclear; do not assume the same arrangement suits every hull material.

When to consider a trailer

As a practical decision, choose another approved transport arrangement if your proposed roof setup cannot meet every load, mounting, and space limit. A compatible trailer is one option.

Yakima lists the LongArm as providing 4 feet (122 centimeters) of additional truck-bed length with a 60-inch (152-centimeter) wide crossbar, with a 300-pound (136-kilogram) capacity at bed height with the tailgate open and at bed-rail height with its BedRock rack system or a tonneau cover.19

Loading height can also drive that choice. Malone says its MicroSport LowBed redesigns the load-bar support system to lower the bar height to 22 inches, and describes loading and unloading heavy kayaks and gear as simple and safe.20

Check the trailer’s payload

Check the trailer’s model-specific payload—the maximum weight it can carry, including the boats—and your vehicle’s towing guidance before choosing one. Also check that the hitch—the towing attachment on the car—is rated for the trailer’s load.4 Use those checks to make the decision, rather than a fixed boat-count threshold. Kayak trailers cover that option.

Where next

Return to kayak care and transport for the wider guide.

Use roof load limits explained to check allowances and kayak roof racks compared to compare arrangements. For loading help, see lift assist and loading a kayak alone.

Footnotes

  1. https://www.thule.com/-/s/approved/std.lang.all/71/96/617196.pdf ↩ ↩2 ↩3 ↩4 ↩5 ↩6 ↩7 ↩8 ↩9 ↩10 ↩11

  2. https://assets.yakima.com/product/instructions/8004041/1 ↩ ↩2 ↩3 ↩4 ↩5 ↩6 ↩7 ↩8 ↩9 ↩10

  3. https://www.thule.com/-/s/approved/std.lang.all/17/56/671756.pdf?rev=1.4 ↩ ↩2 ↩3 ↩4

  4. https://maloneautoracks.com/FAQ.html ↩ ↩2 ↩3 ↩4 ↩5 ↩6 ↩7 ↩8

  5. https://www.rei.com/learn/expert-advice/transporting-kayak-canoe.html ↩ ↩2 ↩3 ↩4 ↩5 ↩6

  6. https://assets.yakima.com/product/instructions/8004073/1 ↩ ↩2 ↩3 ↩4 ↩5 ↩6 ↩7

  7. Wayback Machine copy captured March 10, 2026 of https://www.rei.com/learn/expert-advice/how-to-choose-the-right-size-cargo-box.html ↩

  8. https://cdn.shopify.com/s/files/1/0714/1995/3466/files/YAKIMA_2026_-_Load_Rating_Document_-_REV_E.pdf?v=1783391650 ↩

  9. https://www.seat.com/datamanual-manual/ateca/my21_w48/en-uk/ATECA_11_20_EN.pdf ↩

  10. https://www.theaa.com/driving-advice/safety/overloading-your-car ↩

  11. https://yakimasupport.zendesk.com/api/v2/help_center/en-us/articles/360000173471.json ↩

  12. https://www.thule.com/en-us/water-racks ↩

  13. https://yakima.com/products/bigstack ↩ ↩2 ↩3 ↩4 ↩5

  14. https://yakima.com/products/jaylow ↩ ↩2 ↩3 ↩4 ↩5 ↩6 ↩7

  15. https://www.thule.com/en-us/water-racks/kayak-and-canoe-racks/thule-compass-_-890000 ↩ ↩2 ↩3 ↩4

  16. Wayback Machine copy captured December 7, 2025 of https://www.rei.com/learn/expert-advice/car-racks.html ↩

  17. https://www.thule.com/en-us/water-racks/kayak-and-canoe-racks/thule-hullavator-pro-_-898010 ↩ ↩2 ↩3

  18. https://www.nrs.com/yakima-jaylow-kayak-rack/pri3 ↩

  19. https://yakima.com/products/longarm ↩

  20. https://maloneautoracks.com/MicroSport-TM-LowBed-TM-2-Boat-Trailer.html ↩